Front View - Lightware UMX-HDMI-140 Series User Manual


  
2. Product Overview
2.1. Front View
1 2 3
VGA input D-SUB connector for analog video signal.
1
2 Audio1 input 3.5 mm Jack connector for asymmetric analog audio input signal.
3 HDMI input HDMI connector for DVI video or HDMI video and audio.
DisplayPort input DisplayPort connector for DisplayPort audio/video signal.
4
Input Status LEDs LEDs give feedback about the current status of the unit and input signals.
5
See the details in the next section.
6 Video Select Button for switching between video sources.
button
Reset button Pushing the button reboots the unit.
7
8 Audio Select Button for switching between audio sources.
button
Show Me button Special functions can be reached using this button (bootload mode, DHCP
9
settings, restore factory default settings, condition launching in
Manager).
INFO:
Both UMX-HDMI-140 and UMX-HDMI-140-Plus have the same look and controls on the front panel.
4 5 6 7 8 9
Applied firmware package: v1.2.0 | LDC software: v2.4.1b7
UMX-HDMI-140 series– User's Manual
Status LEDs
Input Status LEDs
OFF: Input is not selected.
BLINKING: Input is selected, and signal is not detected.
ON: Input is selected and signal is present.
ATTENTION!
When Dark mode is enabled, input status LEDs are off, even though the device is fully
functional.
LIVE LED
OFF:
BLINKING: (slow, 1 sec)
BLINKING: (fast, 0,5 sec)
ON:
AUTOSELECT LED
Event
OFF: Autoselect function is disabled.
BLINKING: Autoselect function is enabled, searching for signal (the video input LEDs are also blinking).
ON: Autoselect function is enabled, the active video signal is found (the selected video input's LED
is also ON).
Device is not powered.
Device is powered and operational.
Device is in firmware upgrade mode.
Device is powered but not operational.
14