Factory Default Settings - Lightware UMX-HDMI-140 Series User Manual


  
11. Appendix
11.6. Factory Default Settings
Parameter
Video
Audio
HDCP
Autoselect
Emulated EDID on analog video inputs
Emulated EDID on digital video inputs
Test pattern mode
Test pattern resolution
Test pattern color (RGB code)
Test pattern resolution on Testpattern
input (I6)
Test pattern color (RGB code) on
Testpattern input (I6)
Output HDMI mode
Output HDCP mode
Power 5V mode
Color space
Analog audio port settings (I1 and I5)
Volume
Balance
IP address
Subnet mask
Static gateway
DHCP
LW2 port number
LW3 port number
HTTP port number
Setting/Value
Crosspoint settings
I6 (Testpattern)
I1 (Analog audio in 1)
Video port settings
Enabled
Enabled, Last detected
Factory #89: Universal Analog EDID
Dynamic #1: Copy EDID from connected sink device.
Auto
640x480p
#7F7F7F (grey)
640x480p
#108020 (green)
Auto
Auto
Always on
Auto
0.00 dB (100%)
50 (center)
Network settings
192.168.0.100
255.255.255.0
192.168.0.1
Disabled
10001
6107
80
Applied firmware package: v1.2.0 | LDC software: v2.4.1b7
UMX-HDMI-140 series– User's Manual
Parameter
Control protocol
Baud rate
Databits
Parity
Stopbits
Operation mode
Recognizer delimiter*
Recognizer Timeout*
Recognizer Active property timeout*
Command injection port nr.
Command injection status
Command injection input port nr.
Command injection output port nr.
Output level
Direction
* Only in UMX-HDMI-140-Plus model.
Setting/Value
RS-232 settings
LW2
57600
8
No
1
Event Manager / Control / Command Injection
0D0A
0 (disabled)
50
8001
IR port settings
Enabled
9001
9002
GPIO port settings
High
Input
121