The Built-In Miniweb; Opening The Miniweb - Lightware UMX-HDMI-140 Series User Manual


  
5. Software Control - Lightware Device Controller
5.11. The Built-in Miniweb
The default control page allows the followings:
▪ Source selection: This block can be used to select an input or
enable/disable the Autoselect remotely e.g. from a mobile
device.
▪ Action triggers: The action trigger buttons can be used to perform
a configured Event Action without waiting for the condition to
occur. This can be done remotely by a mobile device, too.
5.11.1. Opening the Miniweb
The Miniweb is available by:
▪ Opening the web browser and typing the IP address of the desired
device in the address line,
▪ Launching the LDC, connecting to the device, navigating to
Settings/Status and pressing the Open miniweb button.
If the Miniweb exists the page will be opened. If not, the status page
will be displayed (which is also available by opening the
<IP_address>/status.html address).
The Factory Default Status Page (status.html)
#miniweb #builtinweb #web
UMX-HDMI-140 series– User's Manual
The Default Control Page Displayed in a Desktop Browser and in a Mobile Device
Applied firmware package: v1.2.0 | LDC software: v2.4.1b7
54