Autoselect - Input Priority Query; Autoselect - Input Priority Change; Network Configuration; Ip Status Query - Lightware UMX-HDMI-140 Series User Manual


  
6. LW2 Programmer's Reference
6.4.10. Autoselect - Input Priority Query
The settings of audio or video autoselect input priority can be queried as follows.
Command and Response
ȩ {PRIO_<layer><out>=?}
Ȩ (PRIO_<layer><out>=<in1_prio>;<in2_prio>;...;<inX_prio>)CrLf
Parameters
Parameter Parameter description
<layer> The layer of the HDMI signal
Priority number of the input
<in_prio>
ports.
Example
ȩ {prio_v1=?}
Ȩ (PRIO_V1=0;1;2;3;4)
Explanation
The video signal of the VGA port has the highest priority, the DVI-A has the lowest priority.
6.4.11. Autoselect - Input Priority Change
The settings of audio or video autoselect input priority can be changed as follows.
Command and Response
ȩ {PRIO_<layer><out>=<in1_prio>;<in2_prio>}
Ȩ (PRIO_<layer><out>=<in1_prio>;<in2_prio>;...;<inX_prio>)CrLf
Parameters
Parameter Parameter description
<layer> The layer of the HDMI signal
Priority number of the input
<in_prio>
ports.
Example
ȩ {prio_a1=1;0;2;3;4;5}
Ȩ (PRIO_A1=1;0;2;3;4;5)
ATTENTION!
Always set all the priority of the ports when changing, otherwise, the change will not be
executed and the response will be the current setting (like querying the priority setting).
Value Parameter value
A Audio layer
V Video layer
Priority numbers from 0 to 5, the
0; 1; 2; ... 5
highest priority is 0, the lowest is 5.
Value Parameter value
A Audio layer
V Video layer
Priority numbers from 0 to 5, the
0; 1; 2; ... 5
highest priority is 0, the lowest is 5.
Applied firmware package: v1.2.0 | LDC software: v2.4.1b7
UMX-HDMI-140 series– User's Manual
6.5. Network Configuration
6.5.1. IP Status Query
The network configuration of the device can be queried as follows.
Command and Response
ȩ {IP_STAT=?}
Ȩ (IP_STAT=<mode>;<ip_address>;<subnet_mask>;<gateway_addr>)CrLf
Parameters
Parameter
<mode>
DHCP (dynamic IP address)
<ip_address>
Current subnet mask of the
<subnet_mask>
Current gateway address of
<gateway_address>
Example
ȩ {ip_stat=?}
Ȩ (IP_STAT=0;192.168.0.75;255.255.255.0;192.168.0.1)
Explanation
The device has a static (fix) IP address: 192.168.0.75; the subnet mask is 255.255.255.0, the gateway
address is 192.168.0.1.
#network #ipaddress #dhcp
Parameter description Value
0 Static IP address
Static IP address setting or
1 DHCP
Current IP address of the IP address (four decimal octets
device separated by dots).
Subnet mask (four decimal octets
device separated by dots).
Gateway address (four decimal
the device octets separated by dots).
65
Parameter value