Gateway Address Query; Gateway Mask Setting; Apply Network Settings; Settings - Lightware UMX-HDMI-140 Series User Manual


  
6. LW2 Programmer's Reference
6.5.6. Gateway Address Query
Gateway address can be queried as follows.
Command and Response
ȩ {IP_GATEWAY=?}
Ȩ (IP_GATEWAY=<gateway_address>)CrLf
Parameters
Parameter Parameter description
Current gateway address of
<gateway_address>
the device
Example
ȩ {ip_gateway=?}
Ȩ (IP_GATEWAY=192.168.0.1)
6.5.7. Gateway Mask Setting
Gateway address can be set as follows.
Command and Response
ȩ {IP_GATEWAY=<gateway_address>}
Ȩ (IP_GATEWAY=<gateway_address>)CrLf
Parameters
Parameter Parameter description
Current gateway address of
<gateway_address>
the device
Example
ȩ {ip_gateway=192.168.0.1}
Ȩ (IP_GATEWAY=192.168.0.1)
UMX-HDMI-140 series– User's Manual
Value Parameter value
Gateway address (four decimal
octets separated by dots).
Value Parameter value
Gateway address (four decimal
octets separated by dots).
Applied firmware package: v1.2.0 | LDC software: v2.4.1b7
6.5.8. Apply Network Settings
Applying the network settings and restart the network interface.
ATTENTION!
The command is always requires as the last step for applying the modified network settings.
Command and Response
ȩ {IP_APPLY}
Ȩ (IP_APPLY)CrLf
Example
ȩ {ip_apply}
Ȩ (IP_APPLY)
6.6. RS-232 Settings
6.6.1. RS-232 Mode Setting
RS -232 mode can be set as follows. See more details about RS -232 modes in the
#rs232 #rs-232 #serial #commandinjection
Command and Response
ȩ {RS232=<mode>}
Ȩ (RS232=<mode>)CrLf
Parameters
Parameter Parameter description
<mode> RS-232 operation mode
Example
ȩ {rs232=control}
Ȩ (RS232=CONTROL)

INFO: The current RS-232 mode can be queried by the {RS232=?} command.
67
Serial Interface section.
Value Parameter value
CONTROL Control mode
CI Command injection mode
PASS Event Manager (Pass-through) mode