Device Label Query; View Installed Board; View Firmware For All Controllers; Restarting Of The Device - Lightware UMX-HDMI-140 Series User Manual


  
6. LW2 Programmer's Reference
6.3.7. Device Label Query
Command and Response #label #devicelabel
ȩ {label}
Ȩ (LABEL=<device_label>)CrLf
Example
ȩ {label}
Ȩ (LABEL=UMX-HDMI-140_ConferenceRoom)
6.3.8. View Installed Board
Shows the hardware name and revision of the installed cards.
Command and Response
ȩ {is}
Ȩ (SL#·0·<mb_desc>)CrLf
Ȩ (SL·END)CrLf
Example
ȩ {is}
Ȩ (SL# 0 UMX-HDMI-140-Plus)
Ȩ (SL END)
6.3.9. View Firmware for All Controllers
Shows the firmware versions of all installed controllers.
Command and Response
ȩ {fc}
Ȩ (CF·<device>·<firmware_version>)CrLf
Ȩ (CF·END)CrLf
Example
ȩ {fc}
Ȩ (CF UMX-HDMI-140 1.2.0b8 r45)
Ȩ (CF END)
#firmwareversion
Applied firmware package: v1.2.0 | LDC software: v2.4.1b7
UMX-HDMI-140 series– User's Manual
6.3.10. Restarting of the Device
The device can be restarted without unplugging power.
Command and Response
ȩ {rst}
Ȩ
Example
ȩ {rst}
Ȩ
6.3.11. Health Status Query
Internal voltages and measured temperature values are shown.
Command and Response
ȩ {st}
Ȩ (ST·<health_status>)CrLf
Example
ȩ {st}
Ȩ (ST CPU 12.01V 4.98V 1.83V 1.27V 37.76C 37.83C)
6.3.12. Recalling Factory Default Settings
All settings and parameters are reset to factory default, see the table in the
#factory
Command and Response
ȩ {factory=all}
Ȩ (FACTOR Y ALL...)CrLf
Example
ȩ {factory=all}
Ȩ (FACTORY ALL...)
#restart #reboot #reset
#status
Factory Default Settings section.
61