Query The Preferred Resolution Of An User Edid; Emulating An Edid To An Input Port; Emulating An Edid To All Input Ports; Copy An Edid To User Memory - Lightware UMX-HDMI-140 Series User Manual


  
7. LW3 Programmers' Reference
7.14.3. Query the Preferred Resolution of an User EDID
Command and Response
ç GET·/EDID/U/<user>.PreferredResolution
pr·/EDID/U/<user>.PreferredResolution=<resolution>
æ
Example
ç GET /EDID/U/U2.PreferredResolution
æ pr /EDID/U/U2.PreferredResolution=1920x1080p60.00Hz
7.14.4. Emulating an EDID to an Input Port
Command and Response
ç CALL·/EDID:switch(<dynamic|user|factory>:<emulated>)
æ mO·/EDID:switch
Example
ç CALL /EDID:switch(F49:E1;F27:E2)
æ mO /EDID:switch
7.14.5. Emulating an EDID to All Input Ports
Command and Response
ç CALL·/EDID:switchAll(<dynamic|user|factory>)
æ mO·/EDID:switchAll
Example
ç CALL /EDID:switchAll(F47)
æ mO /EDID:switchAll
7.14.6. Copy an EDID to User Memory
Command and Response
ç CALL·/EDID:copy(<dynamic|emulated|factory|user>:<user>)
æ mO·/EDID:copy
Example
ç CALL /EDID:copy(D1:U1)
æ mO /EDID:copy
The EDID of the last connected sink of D1 (Output 1) has been copied to U1.
UMX-HDMI-140 series– User's Manual
7.14.7. Deleting an EDID from User Memory
Command and Response
ç CALL·/EDID:delete(<user>)
æ mO·/EDID:delete
Example
ç CALL /EDID:delete(U1;U2;U6)
æ mO /EDID:delete
7.14.8. Resetting the Emulated EDIDs
Command and Response
ç CALL·/EDID:reset()
æ mO·/EDID:reset
Example
ç CALL /EDID:reset()
æ mO /EDID:reset
Calling this method switches all emulated EDIDs to factory default one. See the table in the
Settings
7.15. GPIO Port Configuration
INFO:

7.15.1. Set the Direction of a GPIO Pin
Command and Response
SET·/MEDIA/GPIO/<GPIO_port>.Direction=<direction>
ç
pw·/MEDIA/GPIO/<GPIO_port>.Direction=<direrction>
æ
Parameters
Example
ç SET /MEDIA/GPIO/P1.Direction=I
æ pw /MEDIA/GPIO/P1.Direction=I
Applied firmware package: v1.2.0 | LDC software: v2.4.1b7
section.
Use the GET command to query a parameter.
#gpio
Parameter Parameter description
<GPIO_port> GPIO pin number
Direction of the
<direction>
communication
98
Factory Default
Value Parameter value
0 ...8 GPIO pin number 1 to 8
I Input
O Output