Settings Menu; Status Tab; Network Tab - Lightware MX2-4x4-HDMI20-CA User Manual


  
6. Software Control – Lightware Device Controller
7.9. Settings Menu
7.9.1. Status Tab
General information about the product is displayed in this tab:
▪ Device name (read-only), Device label (editable), Part number and Serial number,
▪ Firmware versions;
▪ Hardware versions,
▪ Temperature values, Voltages, Operation time.
▪ In -R suffixed models: PSU status can be seen in this tab (PSU1/PSU2: running / failed)
#status #firmwareversion #label #devicelabel
Status Tab in the Settings Menu
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
MX2-HDMI20 series – User's Manual
7.9.2. Network Tab
Network-related settings are available on the tab.
When dynamic IP address is used, the DHCP option is ticked; the IP settings of the matrix is shown in the
first three lines. When static IP address is used, the DHCP option shall be unticked and below three lines
can be used to define the IP settings. The device can be controlled by LW3, LW2 protocols, or P#2 protocol.
ATTENTION! Connecting to the matrix via Ethernet and using LW2 port no. (default is 10001) the device
accepts LW2 protocol commands. Using LW3 port no. (default is 6107) the device accepts LW3 protocol
commands.
#network #ipaddress #dhcp
Network Tab in the Settings Menu
64