Lightware MX2-4x4-HDMI20-CA User Manual page 100


  
9. LW3 Programmers' Reference
Audio Output Port Settings
Audio Mode Setting
SET·/MEDIA/PORTS/VIDEO/<out>/ANALOGAUDIO.AudioMode=<audio_mode>
Ý
Setting the Volume (Exact Value)
SET·/MEDIA/PORTS/VIDEO/<out>/ANALOGAUDIO.VolumedB=<vol_value>
Ý
Setting the Volume (by Step Value)
Ý CALL·/MEDIA/PORTS/VIDEO/<out>/ANALOGAUDIO:stepVolumedB(<step_value>)
Setting the Balance (Exact Value)
SET·/MEDIA/PORTS/VIDEO/<out>/ANALOGAUDIO.Balance=<bal_value>
Ý
Setting the Balance (by Step Value)
Ý CALL·/MEDIA/PORTS/VIDEO/<out>/ANALOGAUDIO:stepBalance(<step_value>)
Setting the Mute State
SET·/MEDIA/PORTS/VIDEO/<out>/ANALOGAUDIO.Mute=<mute_state>
Ý
Preset Handling
Creating a New Preset
Ý CALL·/MEDIA/PRESET:create(<preset_name>,VIDEO)
Saving the Settings to an Existing Preset
Ý CALL·/MEDIA/PRESET/<preset_name>:save(1)
Loading a Preset
Ý CALL·/MEDIA/PRESET/<preset_name>:load()
Renaming a Preset
Ý CALL·/MEDIA/PRESET:rename(<Old_name>,<New_name>)
Network Settings
Querying the Current IP Address
Ý GET·/MANAGEMENT/NETWORK.IpAddress
Setting a Dynamic IP Address
SET·/MANAGEMENT/NETWORK.DhcpEnabled=<DHCP_state>
Ý
Static IP Address Settings
Setting an IP address
SET·/MANAGEMENT/NETWORK.StaticIpAddress=<IP_address>
Ý
Subnet Mask Setting
SET·/MANAGEMENT/NETWORK.StaticNetworkMask=<Net_mask>
Ý
MX2-HDMI20 series – User's Manual
Gateway Setting
SET·/MANAGEMENT/NETWORK.StaticGatewayAddress=<Gateway_address>
Ý
EDID Management
Querying the Emulated EDIDs
Ý GET·/EDID.EdidStatus
Setting the Emulated EDID
Ý CALL·/EDID:switch(<Source>:<Destination>)
Copying an EDID into the User EDID Memory
Ý CALL·/EDID:copy(<source>:<destination>)
RS-232 Port Settings
Setting the Current Command Protocol
SET·/MANAGEMENT/SERIAL.Protocol=<prot_mode>
Ý
Setting the Baud Rate
SET·/MANAGEMENT/SERIAL.Baudrate=<BAUD_value>
Ý
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
100