Edid Management; Querying The Emulated Edids; Setting The Emulated Edid; Copying An Edid Into The User Edid Memory - Lightware MX2-4x4-HDMI20-CA User Manual


  
9. LW3 Programmers' Reference
9.14. EDID Management
9.14.1. Querying the Emulated EDIDs
Command and Response #edid
Ý GET·/EDID.EdidStatus
pr·/EDID.EdidStatus=<E1_EDID>;<E2_EDID>;...;<E8_EDID>
Ü
Parameters
The <E#_EDID> parameters mean the I1-I8 (E1-E8) input ports one after the other. The value of the parameter
shows the location of the currently emulated EDID at the given input port.
Example
Ý GET /EDID.EdidStatus
Ü pr /EDID.EdidStatus=U1;U1;D2;D2;F49;F49;F49;F49
Explanation
The U1 (User) EDID is emulated on Input1 and Input 2. D2 (Dynamic) EDID is emulated on Input3 and Input4,
and F49 (Factory) EDID is emulated on the other input ports.
9.14.2. Setting the Emulated EDID
Command and Response
Ý CALL·/EDID:switch(<Source>:<Destination>)
Ü mO·/EDID:switch=
Parameters
Identifier Parameter description
<source> Source EDID memory
place
<destination> Emulated EDID
memory place
Example
Ý CALL /EDID:switch(F49:E1;F29:E5)
Ü mO /EDID:switch=
Parameter values
F1-F148: Factory presets.
D1-D8: Dynamic EDID from the sink connected to the output port.
U1-U100: User EDID memory.
E1-E8: The emulated EDID memory location of the input port.
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
MX2-HDMI20 series – User's Manual
9.14.3. Copying an EDID into the User EDID Memory
ATTENTION! The (User) EDID memory slot will be overwritten without notification even if it was not empty.
Command and Response
Ý CALL·/EDID:copy(<source>:<destination>)
Ü mO·/EDID:copy=
Parameters
Identifier Parameter description
<source> Source EDID memory
place
<destination> User EDID memory
Example
Ý CALL /EDID:copy(D2:U5;D3:U6)
Ü mO /EDID:copy=
Parameter values
F1-F148: Factory presets.
D1-D8: Dynamic EDID from the sink connected to the output port.
U1-U100: User EDID memory.
U1-U100: The destination User EDID memory slot.
96