Output Ports Menu - Lightware MX2-4x4-HDMI20-CA User Manual


  
4. Front Panel Control
Embedded audio status
▪ Audio type
Sampling frequency
▪
Advanced
▪ Pixel clock
▪ Total resolution
Scrambling
▪
HDMI Settings Submenu (Input)
HDCP #hdcp
The encryption towards the source can be set as follows:
▪ Disable HDCP on input: The connected source will detect that
the sink is not HDCP-compliant and turn off authentication if
the content allows it.
▪ Allow HDCP 1.4 only *: The connected source will detect that the
matrix is compliant with HDCP 1.4 but not compliant with HDCP
2.2.
▪ Allow HDCP 2.2 or HDCP 1.4: The connected source will detect
that the sink is compliant with HDCP 2.2 (factory default
setting).
▪ High Value mode: Any version of HDCP is allowed on the input but the incoming signal is converted to
HDCP 2.2 level encryption, thus, it cannot be switched to HDCP 1.4 sinks.
See more information about HDCP in
*The availability of this setting depends on the hardware version of the input board (V1x_) only in MX2-8x8-
HDMI20 model. The hardware version can be found in
Device Info submenu in the LCD.
Hotplug
The hotplug signal towards the source can be set to Auto, or Forced Off.
Audio Source
Source of the embedded audio can be set in this menu:
Disable/ Video /Analog input *
* Analog option appears when there is an analog audio input beside the chosen video port. -A or -Audio suffix
in the model name refers to the analog audio feature.
HDCP Management section.
Status Tab in the LDC or in the System Settings
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
MX2-HDMI20 series – User's Manual
Analog Audio Submenu
DIFFERENCE: Analog Audio submenu appears when there is an
analog audio input beside the chosen video port. -A or -Audio suffix
in the model name refers to the analog audio feature (see the
Comparison table about the analog audio availability).
Information about the Analog Audio input and the (HDMI) embedded
audio signal is displayed in this submenu.
▪ Audio Source: Disable/ Video/ Analog Input
▪ Audio Gain: adjustable from -12 dB to +35 dB,
Analog Volume: adjustable from 0 (-95dB) to 100% (0dB),
▪
Analog Balance: adjustable from -100 % (Left) to + 100% (Right), 0 means the center.
▪
#audio #analogaudio #volume #balance #gain
3.2.3. Output Ports Menu
When entering the menu the available video output ports are listed. The
icons display information about the port and the outgoing signal (see
below table). Select the desired output port and enter to see the submenu.
Icon Icon is grey
Signal is not encrypted with

HDCP
No audio signal in the video

stream

Signal is not present

Sink is not connected
Menu,

The port is unmuted

The port is unlocked
Model
Icon is white
Signal is encrypted with
HDCP
Audio is embedded in the
video stream
Signal is present
Sink is connected
The port is muted
The port is locked
25