Lightware MX2-4x4-HDMI20-CA User Manual page 136


  
13. Appendix
v1.1.1b4
Release date: 2017-03-09
Bugfix:
▪ Fixed a bug that caused the error registers on the output not to
be cleared correctly resulting in false content in the logs.
▪ Fixed a bug that prevented the internal buzzer from being
disabled.
▪ Fixed a bug that caused the time and date not to be preserved
when the unit was power cycled.
▪ Fixed a bug that limited the number of retry attempts to three
when authentication of the attached display failed.
▪ Fixed a bug that caused some HDCP 1.4 repeaters (e.g. some AV
receivers) not to be authenticated properly.
▪ Fixed a bug that prevented the Lightware Protocol 2 switch
command from working.
▪ Fixed a bug that caused some displays not to authenticate
correctly when they were switched on after being connected to
the matrix.
▪ Fixed a bug where the input port mute caused permanent signal
loss on the input with HDCP2.2 contents.
▪ Fixed a bug resulting in the 4:4:4 to 4:2:0 conversion option to remain
active when the sampling pattern of the input signal was 4:2:0.
▪ Fixed a bug that caused the red picture on the display indicating
that it was not able to decrypt HDCP-encrypted content to flash
when HDCP 2.2 content encryption was used.
▪ Fixed a bug that caused compatibility issues with non-HDMI2.0
products resulting in inappropriate EDID reading.
v1.1.0b3
Release date: 2017-01-31
New feature:
▪ We are introducing automatic fan speed control. Now the fan
speed is set according to the system temperature.
▪ From this version on, HDCP 2.2 is supported by the matrix.
▪ We are introducing support for saving and loading presets.
Presets are used to store crosspoint settings and Mute state for
ports. Current lock state is reserved when loading a preset.
▪ We are introducing front panel USB support. The front panel
USB connector can now be used for connecting the matrix to a
controller computer running the Lightware Device Controller.
MX2-HDMI20 series – User's Manual
v1.0.1b1
Release date: 2016-12-02
Bugfix:
▪ Fixed a bug that caused the IPv6 address not to be displayed in
LDC for the first time.
v1.0.0b1
Release date: 2016-11-20
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
136