Video Input Port Settings (Hdmi And Displayport); Setting The Hdcp State; Muting An Input Port; Unmuting An Input Port - Lightware MX2-4x4-HDMI20-CA User Manual


  
9. LW3 Programmers' Reference

Video Input Port Settings (HDMI and DisplayPort)

9.5.6.
9.5.7. Setting the HDCP State
This setting allows to send non-encrypted content to a non-HDCP compliant display. See more information
in the HDCP Management section.
Command and Response #hdcp
SET·/MEDIA/PORTS/VIDEO/<in>/SETTINGS.HdcpVersion=<HDCP_ver>
Ý
pw·/MEDIA/PORTS/VIDEO/<in>/SETTINGS.HdcpVersion=<HDCP_ver>
Ü
Parameters
Parameter
Identifier
description
<HDCP_ver> HDCP setting
*The availability of this setting depends on the hardware version of the input board (V1x_) of the selected
HDMI port, only in MX2-8x8-HDMI20 model. The hardware version can be found in
in the System Settings Menu, Device Info
Example
Ý SET /MEDIA/PORTS/VIDEO/I1/SETTINGS.HdcpVersion=3
Ü pw /MEDIA/PORTS/VIDEO/I1/SETTINGS.HdcpVersion=3
9.5.8. Muting an Input Port
Command and Response #mute
Ý CALL·/MEDIA/XPVIDEO:muteSource(<in>)
Ü mO·/MEDIA/XP/VIDEO:muteSource=OK
Example
Ý CALL /MEDIA/XP/VIDEO:muteSource(I1)
Ü mO /MEDIA/XP/VIDEO:muteSource=OK
Parameter values
0: HDCP encryption is disabled
1 *: HDCP 1.4 encryption is enabled
2: HDCP 2.2 is enabled
3: High value mode: Any HDCP version is allowed on the input but the
incoming signal is internally converted up to HDCP 2.2 always, thus, the
signal cannot be switched to HDCP 1.4 sinks.
submenu in the LCD.
MX2-HDMI20 series – User's Manual
9.5.9. Unmuting an Input Port
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:unmuteSource(<in>)
Ü mO·/MEDIA/XP/VIDEO:unmuteSource=OK
Example
Ý CALL /MEDIA/XP/VIDEO:unmuteSource(I1;I3)
Ü mO /MEDIA/XP/VIDEO:unmuteSource=OK
9.5.10. Locking an Input Port
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:lockSource(<in>)
Ü mO·/MEDIA/XP/VIDEO:lockSource=OK
Example
Ý CALL /MEDIA/XP/VIDEO:lockSource(I1;I2;I3)
Ü mO /MEDIA/XP/VIDEO:lockSource=OK
9.5.11. Unlocking an Input Port
Status Tab in the LDC or
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:unlockSource(<in>)
Ü mO·/MEDIA/XP/VIDEO:unlockSource=OK
Example
Ý CALL /MEDIA/XP/VIDEO:unlockSource(I1;I3)
Ü mO /MEDIA/XP/VIDEO:unlockSource=OK
INFO: The current setting can be queried by using the
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
#unmute
#lock
#unlock
GET command.
82