Switching An Input To An Output; Disconnect The Output From Any Input; Switching An Input To All Outputs; Multiple Switching - Lightware MX2-4x4-HDMI20-CA User Manual


  
9. LW3 Programmers' Reference
9.5.2. Switching an Input to an Output
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:switch(<in>:<out>)
Ü mO·/MEDIA/XP/VIDEO:switch=OK
Example
Ý CALL /MEDIA/XP/VIDEO:switch(I4:O1)
Ü mO /MEDIA/XP/VIDEO:switch=OK
9.5.3. Disconnect the Output from any Input
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:switch(0:<out>)
Ü mO·/MEDIA/XP/VIDEO:switch=OK
Example
Ý CALL /MEDIA/XP/VIDEO:switch(0:O1)
Ü mO /MEDIA/XP/VIDEO:switch=OK
9.5.4. Switching an Input to All Outputs
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:switchAll(<in>)
Ü mO·/MEDIA/XP/VIDEO:switchAll=OK
Example
Ý CALL /MEDIA/XP/VIDEO:switchAll(I1)
Ü mO /MEDIA/XP/VIDEO:switchAll=OK
TIPS AND TRICKS: All output ports can be disconnected by the '0' value:
CALL /MEDIA/XP/VIDEO:switchAll(0).
MX2-HDMI20 series – User's Manual
9.5.5. Multiple Switching
The whole crosspoint can be set by sending one command as follows.
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:switchMulti(<out1_source>;<out2_source>;...;<out8_source>)
Ü mO·/MEDIA/XP/VIDEO:switchMulti=OK
The source is not required to set on all output ports (see the Example2).
Parameters
The <out#_source>
the input port switched to the given output port.
Example1
Ý CALL /MEDIA/XP/VIDEO:switchMulti(I1;I2;I3;I4;I5;I6;I7;I8)
Ü mO /MEDIA/XP/VIDEO:switchMulti=OK
Example2
Ý CALL /MEDIA/XP/VIDEO:switchMulti(I1;I2;;;I5)
Ü mO /MEDIA/XP/VIDEO:switchMulti=OK
Applied firmware package: v1.7.0 | LDC software: v2.5.1b5
parameters mean the output ports one after the other. The value of the parameter shows
81