Whiz Operational Manual
Check that the secondary battery power button on the bottom of the machine is off (see "P44
7-4 Secondary Battery Power Button"). At this time, remove the protective film of the cliff
sensor as well (Fig. 6-22 ).
Fig. 6-22
4
Check the marks on the left and right ends of the new brush.
The mark on the left
■ When the machine is laid down with the front side facing upwards, you will see the sockets of the
brush compartment. These sockets correspond to the right and left sockets of the brush.
5
Attach the right end of the brush in the socket with the matching marking in the brush
compartment (Fig. 6-23).
Fig. 6-23
35 / 145
The mark on the right