SoftBank Whiz Support Manual
Hide thumbs
Also See for Whiz:
- Operational manual (147 pages) ,
- Operation manual (123 pages) ,
- Manual (15 pages)
Advertisement
Quick Links
Whiz Support Guide
This support guide describes how to deal with problems that may occur during operation, and
Machine maintenance. Please check how to handle a problem and procedures. For moredetails,
please refer to "Whiz Quick Guide" included in the Machine for basic operations and maintenance.
The latest version of this document and the Whiz Operational Manual can be found on "help.
meetwhiz.com".
※ Please note that screen specifications on the touch display are subject to change without notice
The Machine has Left the Cleaning Route
Error Message
1
1
Tap
and close the error
message
4 4
Check the red cleaning
route has turned into the
white route
ROBOT IS OFF PATH
CANCEL ROUTE
The Secondary Battery is Off
Error Message
1 1
Tap
and close the error
message
ROBOT IS OFF PATH
2 2
Pull the steering handle
5 5
Stow the steering handle
SECONDARY BATTERY OFF
3 3
Return the Machine to
the correct cleaning route
ROBOT IS OFF PATH
CANCEL ROUTE
6 6
Press the autonomous
cleaning start / stop button
2021.01
1
Advertisement
Related Manuals for SoftBank Whiz
Summary of Contents for SoftBank Whiz
- Page 1 Machine maintenance. Please check how to handle a problem and procedures. For moredetails, please refer to "Whiz Quick Guide" included in the Machine for basic operations and maintenance. The latest version of this document and the Whiz Operational Manual can be found on "help. meetwhiz.com".
- Page 2 Obstacles / Steps Detection Error Message CLIFF DETECTED / IMPACT DETECTED and close the error Pull the steering handle Return the Machine to message straight up the correct cleaning route Avoid the obstacle when moving the Machine. ROBOT IS OFF PATH CANCEL ROUTE Check the red cleaning Stow the steering handle...
- Page 3 Maintenance To keep the Machine in good condition, carrying out maintenance every time after use or once a week will be needed. ※ Carry out maintenance depending on the amount of dust collected. Discard any Dust in the Hopper Tray Wipe off Dust or Dirt on Each Sensor Pull the tray out from the side by its handle.
- Page 4 Replace with a New Dustbag When the dustbag is full and the error message appears, replace with a new dustbag. at the upper right Remove the dustbin cover Remove the used dustbag Make sure the side of the Check the dustbin pin Close the dustbin cover is afloat illustration of the new dustbag...