Hopper Tray - SoftBank Whiz Operational Manual

Whiz Operational Manual

13-1-4 Hopper Tray

Empty the hopper tray after every cleaning. Remove and replace the hopper tray following the steps
below.
The hopper tray is shaped as below (Fig. 13-21), and is located on the bottom of the machine (see
"P25 5 Names of Parts").
Fig. 13-21
■ Do not remove the hopper tray while the machine is laying on its side. Doing so will allow dirt in the
hopper tray to scatter.
■ Be careful not to injure yourself when removing the hopper tray.
WARNING
1
Pull the hopper tray out by its handle (Fig. 13-22).
2
Pull the hopper tray out on the left (direction of arrow) (Fig. 13-23).
■ The hopper tray cannot be pulled out on the right.
■ To ensure adequate space for pulling the hopper tray out, orient the rear caster backward as shown in
Fig. 13-23.
When replacing the hopper tray, turn off the main power switch of the machine
beforehand and remove the hopper tray from the machine.
Fig. 13-22
Fig. 13-23
119 / 145