SoftBank Whiz Operational Manual page 144

Whiz Operational Manual
Terminology
Emergency stop
E
button
G Grounding chain
Group function
H HEPA filters
HEPA filter covers
Home Location
Code
Hopper tray
L LED lights
Lift handles
M Main power switch
Manual Cleaning
Max power mode
Max power mode
button
Micro-fiber cloth
Button used in an emergency. Pressing the emergency stop button
immediately brakes the machine and all functioning stops. (see "P42
7-3 Emergency Stop")
To resume autonomous cleaning after an emergency stop, turn the
emergency stop button to the right to release the emergency stop
and press the autonomous clean start/stop button (see "P55 7-11
Autonomous Clean Start/Stop Button").
Chain for channeling the machine's electrical charge (static electricity)
to the ground. Before using the machine, check that the earth chain is
in contact with the floor.
Function that allows multiple machines to share the cleaning route
(see "P60 9-2-2 Cleaning Routes and Group Function"). It is
necessary to create a group with Whiz Connect Portal beforehand,
and assign the machines to the group.
High-performance exhaust filters located at the exhaust of the
machine for removing dirt and particles. (see "P114 13-1-2 HEPA
Filters")
Removable covers on the machine's exhaust. (see "P114 13-1-2
HEPA Filters")
Code used for having the machine learn where cleaning start/end
points are in autonomous cleaning mode. One code can be used
for the machine to learn six routes. (see "P58 9-2 Home Location
Codes")
Tray for holding dirt collected by the brush. Discard any dirt in the tray
after every cleaning. (see "P119 13-1-4 Hopper Tray")
LED lights for indicating machine status, safety, and errors. LED lights
are located at positions from the front of the machine to its back, and
light in different colors and patterns. (see "P46 7-5 LED Lights")
Used when lifting the machine from the floor. Be sure to use two
people as a safety precaution when lifting the machine.
Switch for turning on/off the machine. Press "I" to turn the machine on,
and "O" to turn the machine off. (see "P41 7-1 Main Power Switch")
Use the handle for making the machine travel through and clean a
cleaning area manually. (see "P93 10 Manual Cleaning")
Mode with more vacuum power than normal mode. Cleaning in max
power mode is recommended for cleaning especially dirty locations.
(see "P52 7-8 Max Power Mode Button")
Button for switching from normal mode to max power mode. (see
"P52 7-8 Max Power Mode Button")
Cloth used during maintenance of the 2D/3D camera, LIDAR sensor,
and cliff sensor.
143 / 145
Description