Maintenance And Safety; About Maintenance And Safety; Brush - SoftBank Whiz Operational Manual

Whiz Operational Manual

13 Maintenance and Safety

13-1 About Maintenance and Safety

After completing cleaning, carry out maintenance on the following parts every day. Before carrying out
maintenance, make sure to turn off the main power switch on the machine (see "P41 7-1 Main Power
Switch").
■ Brush (see "P109 13-1-1 Brush")
■ HEPA filters (see "P114 13-1-2 HEPA Filters")
■ Dustbag (see "P115 13-1-3 Dustbag")
■ Hopper tray (see "P119 13-1-4 Hopper Tray")
■ Machine repair should only be carried out by technical staff approved by SoftBank Robotics.
■ Turn off the main power beforehand to disinfect the machine with alcohol. Use the amount of
alcohol to some degree that a soft cloth is slightly wet.
Avoid disinfecting Rubber pad, the base of the steering handle (the rubber part), and the wheels.

13-1-1 Brush

Remove the brush, and remove any dirt or hair caught in it as necessary. If the brush is damaged,
replace with a new brush following the steps below.
■ When cleaning the brush, do not pull the brush forcefully. Doing so may damage the brush.
■ If the bottom of the machine is dirty, wipe with a dry cloth.
WARNING
Removing the brush
1
Stow the steering handle (see "P53 7-9 Steering Handle") (Fig. 13-1 ).
When replacing the brush, turn off the main power switch of the machine
beforehand and remove the battery from the machine in order to reduce risk
of shock.
Fig. 13-1
109 / 145