Connecting Adjacent Network Elements - Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual

Connecting adjacent network elements

............................................................................................................................................................................................................................................................
Tools, test equipment and accessories
Listed below are the tools, test equipment and accessories necessary to perform the
procedures in this section.
Quantity
1
1
1
1
1
1
1
............................................................................................................................................................................................................................................................
7 - 2
Description
Screwdriver(s)
ESD Wrist Strap
Multimeter (Optional)
DS1 Error Rate Test Set
DS3 Error Rate Test Set
Personal Computer (PC)
CIT Interface Cable
Optical Power Meter
Comments
A screwdriver(s) with the appropriate
head(s) is (are) required for securing the
mounting screws, repositioning the
mounting brackets, installing the interfacing
cables, and for setting the circuit breakers to
the OFF position.
A wrist strap must be worn when handling
circuit packs. Use the electrostatic discharge
(ESD) jack provided on the shelf.
The voltmeter must be capable of measuring
DC voltage in the 40 to 60 volt range. The
use of the voltmeter is optional since the
shelf will alarm or shut down if the proper
voltage is not supplied.
A DS1 error rate test set is required for
testing of DS1 cabling. A T-BERD 2209 or
equivalent is recommended.
A DS3 error rate test set is required for
testing of DS3 cabling. A T-BERD 2209 or
equivalent is recommended.
8-ft. long RJ45 to 9-pin D-sub serial cable
(Comcode 848748869).
365-372-603R2.0
Issue 1 January 2009