Table of Contents
Advertisement
Stand-alone installation testing
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
17
Click on the
........................................................................................................................................................................................................................
18
Double click on port 1 (OC-N).
........................................................................................................................................................................................................................
19
Select Next.
........................................................................................................................................................................................................................
20
Select Next.
........................................................................................................................................................................................................................
21
Select Finish.
........................................................................................................................................................................................................................
22
Click Yes.
........................................................................................................................................................................................................................
23
Click Yes.
Result:
of the QRSS signal.
........................................................................................................................................................................................................................
24
Remove the test set connections from the DSX-1.
........................................................................................................................................................................................................................
25
Use the e
........................................................................................................................................................................................................................
26
Click on
........................................................................................................................................................................................................................
27
Yes
Click
Result:
from the DSX-1.
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
main (OC-N).
The DS-1 test set should indicate a blue (AIS) signal is being received in place
upd-sys
to send an
GUI
Configuration->Update System->Update All
to issue the command.
This command will remove alarms generated by removing the test signals
command.
.
DS1/E1 testing
6 - 1 3
Advertisement
Table of Contents
