............................................................................................................................................................................................................................................................

Remove the optical fiber jumper from the OC-48 OLIU (at the LGX).

Result:

and NE LEDs should be lit on the SYSCTL circuit pack.

If not still connected from the previous procedure. Connect the Front CIT cable between

the PC and the CIT/RS 232 port or OSI front LAN port of the System Controller and login

to the shelf using the serial/LAN connection and the GUI options on WaveStar

Use the

Click on the

Result:

There should be no alarm indications on the Alcatel-Lucent 1850 TSS-60 shelf.

Repeat this entire procedure for each low speed OC-48 circuit pack equipped in the

Alcatel-Lucent 1850 TSS-60 shelf.

Remove the 15-dB LBO from the OC-48 OLIU.

Replace all protective dust covers on the OC-48 OLIU connectors, that were removed to

perform this procedure.

Repeat this entire procedure for each LNW31, LNW425, LNW427, LNW447, LNW449,

LNW453, LNW455, LNW459 OC-48 OLIU in the Alcatel-Lucent 1850 TSS-60 shelf.

Check off the appropriate box in

N D

........................................................................................................................................................

365-372-603R2.0

Issue 1 January 2009

The FAULT LED should begin flashing on the OC-48 OLIU and only the MN

GUI

window to send the

Configuration -> Update System -> Update All

The flashing FAULT LED should extinguish on the OC-48 OLIU.

T E P S

upd-sys

command.

"Installation checklist" (p.

OC-48 low-speed testing

CIT.

II-5).

6 - 3 7

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 231

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents