............................................................................................................................................................................................................................................................

Using the appropriate CLETOP stick cleaner (2.5 mm for SC, ST, and FC connectors, 1.25

mm for LC connectors) dampen the stick cleaner with Ethyl alcohol using the alcohol

wipe. Insert the stick cleaner into the adapter rotating the stick 360 degrees while

inserting. Push/rotate stick until the stick cleaner makes contact with the connector. Apply

slight pressure upon contact and rotate stick 360 degrees at least three (3) times.

Remove the stick cleaner rotating it upon removal.

Using a dry CLETOP stick cleaner of appropriate diameter, repeat the above cleaning

procedure. This procedure will clean the side walls of the adapter and the endface of the

circuit pack connector.

Gently insert the Video Fiber Scope probe into the port until the fiber ferrule comes into

view.

Verify that the fiber ferrule is clean. Repeat

meet the requirements specified in

N D

........................................................................................................................................................

B- 1 0

T E P S

Step 1

through

"Connector inspection" (p.

Cleaning/inspecting optical connectors

Step 3

if the fiber does not

B-8).

365-372-603R2.0

Issue 1 January 2009

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 322

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents