Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 159

Transport service switch
Table of Contents

Advertisement

Circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
4
Repeat
function/growth slot. If not, install a 177D or LNW98 Apparatus Blank into the protection
circuit pack slot (D2 or G2 as required).
Note:
provide proper air flow for cooling.
........................................................................................................................................................................................................................
5
Repeat
an LNW402 circuit pack.
........................................................................................................................................................................................................................
6
Check off the appropriate box in the
E
O
N D
........................................................................................................................................................
LNW785 OMD5/8 8-channel low-loss DWDM Optical Mux/Demux
Follow this procedure to install the LNW785 circuit packs in the Alcatel-Lucent 1850
TSS-60 shelf. The LNW785 OMD5/8 circuit pack multiplexes/demultiplexes up to 8
DWDM optical channels.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group slots where
the LNW785 circuit packs will be installed.
........................................................................................................................................................................................................................
2
Remove the first LNW785 circuit pack from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Repeat
function/growth slot. If not, install a 177D or LNW98 Apparatus Blank into the protection
circuit pack slot (D2 or G2 as required).
Note:
provide proper air flow for cooling.
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
Step 2
and
Step 3
if a second LNW402 is required in the companion
177D or LNW98 Apparatus Blanks are required in all unused slots D and G to
Step 2
through
Step 4
S
F
T E P S
Step 2
and
Step 3
if a second LNW785 is required in the companion
177D or LNW98 Apparatus Blanks are required in all unused slots D and G to
if an additional function/growth group is to be equipped with
"Installation checklist" (p.
Initial circuit pack installation
I-6).
4 - 1 7

Advertisement

Table of Contents
loading

Table of Contents