Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 160

Circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
5
Repeat
an LNW785 circuit pack.
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW37 (OC-3 4 port PTM OLIU) or LNW45 (OC-3 8 port PTM OLIU)
Follow this procedure if installing the LNW37 (OC-3 4 port PTM OLIU) or LNW45
(OC-3 8 port PTM OLIU) circuit packs into the Alcatel-Lucent 1850 TSS-60 shelf.
Note:
containing the circuit pack, the other containing the ordered quantity of PTMs. This
procedure will consist of two parts.
– Install the circuit card.
– Install the PTM.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group(s) and/or
growth slot(s) where LNW37 or LNW45 circuit pack will be installed.
........................................................................................................................................................................................................................
2
Remove the LNW37 or LNW45 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
If a companion circuit pack is required, continue with the
LNW98 Apparatus Blank into the protection circuit pack slot (D2 or G2 as required), then
proceed to
Important!
to provide proper air flow for cooling.
........................................................................................................................................................................................................................
5
Remove the second LNW37 or LNW45 from the packing material.
............................................................................................................................................................................................................................................................
4 - 1 8
Step 2 through Step 4
S
F T E P S
The LNW37 or LNW45 circuit pack comes in two separate boxes. One box
Step 7.
177D or LNW98 Apparatus Blanks are required in all unused slots D and G
if an additional function/growth group is to be equipped with
"Installation checklist" (p.
Initial circuit pack installation
I-6).
Step 5. If not, install a 177D or
365-372-603R2.0
Issue 1 January 2009