Table of Contents
Advertisement
Stand-alone node setup
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1850 TSS-60 shelf initialization
Description
This section provides instructions for initializing the Alcatel-Lucent 1850 TSS-60 shelf, to
ensure that all circuit pack databases are correct for the current shelf and software release.
The procedures in this section assume that the SYSCTL is installed and the circuit packs
have all been installed in the shelf as described in the preceding sections.
Shelf initialization procedure
Proceed as follows:
........................................................................................................................................................................................................................
1
Log on to the Alcatel-Lucent 1850 TSS-60 shelf using the CIT software as described in
the
"Use of WaveStar
........................................................................................................................................................................................................................
2
Use the
........................................................................................................................................................................................................................
3
Click Fault:Reset:Initialize System
........................................................................................................................................................................................................................
4
Click OK
........................................................................................................................................................................................................................
5
Click Yes to the Warning Message.
Result:
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
5 - 1 4
®
CIT software" (p.
GUI
window and send the following command.
The shelf will reset and end the CIT session.
S
F
T E P S
Alcatel-Lucent 1850 TSS-60 shelf initialization
5-8).
"Installation checklist" (p.
II-5).
365-372-603R2.0
Issue 1 January 2009
Advertisement
Table of Contents
