Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 273

Connecting adjacent network elements
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
21
Disconnect the fiber cable from the OUT connector on the OLIU at one end of the span.
At the other end, verify that the associated FAULT LED is flashing, indicating a loss of
signal. Reconnect the fiber and repeat the process for the other direction of transmission.
........................................................................................................................................................................................................................
22
In order to enable communications with the adjacent Alcatel-Lucent 1850 TSS-60 nodes,
........................................................................................................................................................................................................................
23
Use the
........................................................................................................................................................................................................................
24 Configure DCC Terminations
The
........................................................................................................................................................................................................................
25 Port AID:
For
........................................................................................................................................................................................................................
26 OSI Over DCC
For
........................................................................................................................................................................................................................
27 LAPD Roll:
For
........................................................................................................................................................................................................................
28
Click Apply to send the command.
........................................................................................................................................................................................................................
29 Port AID:
For
........................................................................................................................................................................................................................
30 OSI Over DCC
For
........................................................................................................................................................................................................................
31 LAPD Roll:
For
........................................................................................................................................................................................................................
32
Click Apply to send the command.
........................................................................................................................................................................................................................
33
Set the timing to Free Running at ALU-TSS-60-1 and Line ALU-TSS-60-2.
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
GUI
to turn off the DCCs.
select dcc-m1-1
enabled
select
user-side
select
select dcc-m2-1.
enabled
select
Network-side
select
Configuration -> DCC Terminations
window will be displayed.
.
.
.
.
Fiber installation
7 - 9