Table of Contents
Advertisement
Stand-alone installation testing
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
7
Select Next.
........................................................................................................................................................................................................................
8
Select Rate= VT1.5: Type of Cross-connect= UPSR Add/Drop.
........................................................................................................................................................................................................................
9
Select Next.
........................................................................................................................................................................................................................
10
Select Range= Single VT.
........................................................................................................................................................................................................................
11
Select m1-1-1-1-1 to a1-1-1-1 (if using a combo card) or [d,g] if using the function slots.
........................................................................................................................................................................................................................
12
Click Finish to issue the command.
Result:
B8ZS formatting.
If an error-free signal is not received:
Verify that the DS-1 line coding format is set to B8ZS using the
•
Group
Verify that the LBOs are set according to cable length using the
•
Group
Check DS-1 cabling for proper connections.
•
Check the Test set for proper framing.
•
........................................................................................................................................................................................................................
13
Use the GUI command to delete the cross-connect.
........................................................................................................................................................................................................................
14
Click Configuration:Cross-Connections.
........................................................................................................................................................................................................................
15
Select Delete legs of an Existing cross-connection.
........................................................................................................................................................................................................................
16
Select Next.
............................................................................................................................................................................................................................................................
6 - 1 2
The DS-1 test set should indicate it is receiving an error free QRSS signal with
command
command (see
"Setting DS1/E1 LBOs" (p.
View:equipment:VT
View:equipment:VT
6-5).
Issue 1 January 2009
DS1/E1 testing
365-372-603R2.0
Advertisement
Table of Contents
