Connecting To Web-Based Interface - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (configure the wireless network, change the operating mode of the device,
specify the settings of the firewall, etc.).
Start a web browser (see the Before You Begin section, page 17). In the address bar of the web
browser, enter the IP address of the access point (by default, the following IP address is specified:
192.168.0.50). Press the Enter key.
Figure 25. Connecting to the web-based interface of the DAP-600P device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the access
point , make sure that you have properly connected the access point to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the Initial
Configuration Wizard section, page 47).
Figure 26. The page for running the Initial Configuration Wizard.
Page 40 of 235
Installation and Connection