D-Link DAP-600P User Manual page 182

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
To create a new tunnel, click the ADD button (
!
Setting for both devices which establish the tunnel should be the same.
Figure 139. The page for adding an IPsec tunnel. The General Settings section.
You can specify the following parameters:
Parameter
Dynamic IPsec
General Settings
Move the switch to the right to allow a remote host with any public IP
address to connect to the access point via IPsec protocol. Such a
setting can be specified for one IPsec tunnel only. Connection requests
via this tunnel can be sent by a remote host only.
Page 182 of 235
Configuring via Web-based Interface
) in the Tunnels section.
Description