Connecting To Web-Based Interface - D-Link DAP-1360 User Manual

DAP-1360 Wireless N 300 Access Point & Router
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (configure the wireless network, change the operating mode of the device,
specify the settings of the firewall, etc.).
1. Start a web browser (see the Before You Begin section, page 14).
2. In the address bar of the web browser, enter the IP address of the access point (by default,
the following IP address is specified: 192.168.0.50). Press the Enter key.
Figure 15. Connecting to the web-based interface of the DAP-1360 device.
3. On the opened page, enter the username and password for the administrator account in the
Login and Password fields correspondingly (by default, the following username and
password are specified: admin, admin). Then click the Enter link.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the access
point, make sure that you have properly connected the access point to your computer.
Figure 16. The login page.
Page 26 of 212
Installation and Connection