Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (configure the wireless network, change the operating mode of the device,
specify the settings of the firewall, etc.).
Start a web browser (see the Before You Begin section, page 14). In the address bar of the web
browser, enter the IP address of the access point (by default, 192.168.0.50). Press the Enter
key.
Figure 25. Connecting to the web-based interface of the DAP-300P device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the access
point , make sure that you have properly connected the access point to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the Initial
Configuration Wizard section, page 43).
Figure 26. The page for running the Initial Configuration Wizard.
Page 36 of 175
Installation and Connection
Advertisement
Table of Contents
