Ipsec - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

IPsec

This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Advanced / IPsec page, you can configure VPN tunnels based on IPsec protocol.
IPsec is a protocol suite for securing IP communications.
To allow IPsec tunnels, move the Enable switch to the right. Upon that the Tunnels and Status
sections and the Logging level drop-down list are displayed on the page.
In the Status section, the current state of an existing tunnel is displayed.
From the Logging level drop-down list, select a detail level of messages recorded to the system
log or leave the value specified by default. The Basic value is recommended to establish an IPsec
tunnel faster. To view the log, go to the System / Log page (see the Log section, page 211).
Figure 138. The Advanced / IPsec page.
Page 181 of 235
Configuring via Web-based Interface