D-Link DAP-600P User Manual page 163

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
In order to enable the SNMP agent, in the Configuration section, move the Enable SNMP
switch to the right. Then specify the needed parameters.
Parameter
Remote subnet
Hostname
The contact information
for the administrator
System location
After specifying the needed parameters, click the APPLY button.
In order to disable the SNMP agent, in the Configuration section, move the Enable SNMP
switch to the left and click the APPLY button.
If the SNMP manager operates over SNMPv2c, create a read-only community which will be used
by the SNMP manager to get data on the device. To do this, in the Communities section, click the
ADD button and specify the community name in the line displayed. Then click the APPLY button.
To remove a community, click the Delete icon ( ) in the relevant line. Then click the APPLY
button.
Configuration
The IP address of the remote subnet where the SNMP manager is
located.
A name of the access point for identification in the SNMP manager.
Additional information used to contact the administrator of the
access point.
Additional information used to locate the access point.
Page 163 of 235
Configuring via Web-based Interface
Description