D-Link DAP-600P User Manual page 221

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Parameter
Use BOOTP option
Autoconfiguration
server address
File name
File check period
Protocol type
After specifying the needed parameters, click the APPLY button.
If you need to check manually if the current configuration file corresponds to the configuration file
on the ISP's server, click the CHECK STATUS button. The check result will be displayed in the
Status field. If the files are different, the device's settings will be updated.
If the switch is moved to the right, the parameters of your ISP's
server (the address, the location of the configuration file, and the
protocol) are automatically specified using DHCP options 66 and
67. If the Access point or Repeater mode was selected in the
Initial Configuration Wizard, the Dynamic value should be
selected from the Mode of local IP address assignment list on
the Connections Setup / LAN page.
If the switch is moved to the left, the parameters of your ISP's server
should be specified manually.
The IP or URL address of your ISP's server where the configuration
file is stored.
The location of the configuration file on the ISP's server.
A time period (in seconds) between attempts to compare the current
configuration file with the configuration file on the ISP's server.
A protocol for communication with the ISP's server where the
configuration file is stored.
Page 221 of 235
Configuring via Web-based Interface
Description