D-Link DAP-600P User Manual page 138

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
The following fields are available on the page:
Parameter
Bandwidth
Autonegotiation
20/40 (Coexistence)
TX power
Drop multicast
Enable TX
Beamforming
The channel bandwidth for 802.11n standard in the 2.4GHz band
(the 2.4 GHz tab).
•
20 MHz: 802.11n clients operate at 20MHz channels.
• 20/40 MHz: 802.11n clients operate at 20MHz or 40MHz
channels.
• Auto: the access point automatically chooses the most
suitable channel bandwidth for 802.11n clients.
The channel bandwidth for 802.11n and 802.11ac standards in 5GHz
band (the 5 GHz tab).
• 20 MHz: 802.11n and 802.11ac clients operate at 20MHz
channels.
• 20/40 MHz: 802.11n and 802.11ac clients operate at 20MHz
or 40MHz channels.
• 20/40/80 MHz: 802.11ac clients operate at 20MHz, 40MHz,
or 80MHz channels.
• 20/40/80/160 MHz: 802.11ac clients operate at 20MHz,
40MHz, 80MHz, or 160MHz channels.
•
Auto: the access point automatically chooses the most
suitable channel bandwidth for 802.11n and 802.11ac clients.
Available on the 2.4 GHz tab.
Move the switch to the right to let the access point automatically
choose the channel bandwidth (20MHz or 40MHz) depending on
availability of other APs within its operational range (this setting can
substantially lower the data transfer rate of your wireless network).
The switch is displayed when the 20/40 MHz value is selected from
the Bandwidth drop-down list.
The transmit power (in percentage terms) of the access point.
Move the switch to the right to disable multicasting for the access
point's WLAN. Move the switch to the left to enable multicasting
from the WAN connection selected on the Advanced / IGMP page.
TX Beamforming is the signal processing/directing technique which
helps to support a high enough transfer rate in the areas with difficult
conditions for the signal propagation.
Move the switch to the right to improve the signal quality.
Page 138 of 235
Configuring via Web-based Interface
Description