Client - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

Client

On the Wi-Fi / Client page, you can configure the device as a client to connect to a wireless access
point or to a WISP. To configure the 2.4GHz band or 5GHz band, go to the relevant tab.
To configure the access point as a client, move the Enable switch to the right. Upon that the
following fields are displayed on the page:
Parameter
Broadcast wireless
network 2.4 GHz /
Broadcast wireless
network 5 GHz
Connecting to network
Figure 109. The page for configuring the client mode.
If the switch is moved to the left, devices cannot connect to the
access point's WLAN. Upon that the access point can connect to
another access point as a wireless client.
A method for connecting to another access point.
Page 134 of 235
Configuring via Web-based Interface
Description