Table of Contents
Advertisement
DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Figure 118. The window for changing the settings of the access point's port.
In the opened window, specify the needed parameters:
Parameter
Speed
Data transfer mode.
Select the
Auto
value to enable autonegotiation.
selected, the Autonegotiation Modes and Flow сontrol sections
are displayed.
Select the 10M-Half, 10M-Full, 100M-Half, or 100M-Full value
to manually configure speed and duplex mode for the selected port:
•
10M-Half: Data transfer in just
can be
either sent or
of up to 10Mbps.
•
10M-Full:
Data transfer in two directions simultaneously
(data can be sent and received at the same time)
maximum possible
•
100M-Half: Data transfer in just
can be
either sent or
of up to
100Mbps.
•
100M-Full:
Data transfer in two directions simultaneously
(data can be sent and received at the same time)
maximum possible
Page 155 of 235
Configuring via Web-based Interface
Description
one direction at a time
received) at the maximum possible
rate
of up to
10Mbps.
one direction at a time
received)
at the maximum possible
rate
of up to
100Mbps.
When this value is
(data
rate
at the
(data
rate
at the
- Quick Links:
- Access Point or Repeater
Hide quick links:
Advertisement
Table of Contents
