Connecting To Web-Based Interface - D-Link DAP-1360 User Manual

DAP-1360 Wireless N300 Access Point & Router
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (configure the wireless network, change the operating mode of the device,
specify the settings of the firewall, etc.).
Start a web browser (see the Before You Begin section, page 13). In the address bar of the web
browser, enter http://dlinkap/ or http://192.168.0.50/ (the default IP address of
the access point). Press the Enter key.
Figure 17. Connecting to the web-based interface of the DAP-1360 device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the access
point , make sure that you have properly connected the access point to your computer.
After the first access to the web-based interface you need to change the default administrator
password. Enter the new password in the Password and Confirmation fields. You may set any
password except admin. Use digits, Latin letters (uppercase and/or lowercase), and characters
available on the keyboard. Then click the Apply button.
Figure 18. The page for changing the default administrator password.
Remember or write down the new password for the administrator account. In case of losing
!
the new password, you can access the settings of the access point only after restoring the
factory default settings via the hardware WPS/RESET button. This procedure wipes out
all settings that you have configured for your device.
After changing the password the login page opens. Enter the username (admin) in the Login field
and the new password in the Password field, then click the Enter button.
Figure 19. The login page.
Page 28 of 270
Installation and Connection