Wan - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

WAN

This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Connections Setup / WAN page, you can create and edit connections used by the access
point.
Figure 75. The Connections Setup / WAN page. The simplified mode.
To edit an existing connection, click the EDIT button. On the opened page, on the Basic tab, the
mandatory settings of this connection will be displayed. To view all available settings of the WAN
connection, go to the All Settings tab. Change the needed parameters and click the APPLY
button.
To disconnect a connection and establish it again, click the RECONNECT button.
To remove all existing connections and create a new one, click the CHANGE CONFIGURATION
button. Upon that the connection creation page opens.
To create several WAN connections, go to the advanced mode. To do this, click the ADVANCED
MODE button.
Page 89 of 235
Configuring via Web-based Interface