Creating Pppoe Ipv6 Or Pppoe Dual Stack Wan Connection - D-Link DAP-600P User Manual

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual

Creating PPPoE IPv6 or PPPoE Dual Stack WAN Connection

On the connection creation page, go to the All Settings tab. Then select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 93. The page for creating a new PPPoE IPv6 connection. Selecting a connection type.
Parameter
Interface
Enable connection
Connection name
The drop-down list is displayed if additional WAN interfaces are
specified in the system (see the VLAN section, page 159).
A physical or virtual WAN interface to which the new connection
will be assigned.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
Available for the advanced mode only.
A name for the connection for easier identification.
Page 109 of 235
Configuring via Web-based Interface
Description