D-Link DAP-600P User Manual page 180

DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
The following elements are available on the page:
Parameter
SIP
RTSP
PPPoE pass through
IPsec pass through
L2TP pass through
PPTP pass through
After specifying the needed parameters, click the APPLY button.
9 On the Connections Setup / WAN page, create a WAN connection, move the SIP switch to the right on the
Advanced / ALG/Passthrough page, connect an Ethernet cable between the LAN port of the access point and
the IP phone. Specify SIP parameters on the IP phone and configure it to obtain an IP address automatically (as
DHCP client).
Move the switch to the right to enable SIP. Such a setting allows
using the SIP ALG function. This function allows VoIP traffic to
pass through the NAT-enabled access point.
Move the switch to the right to enable RTSP. Such a setting allows
managing media stream: fast forward streaming audio/video, pause
and start it.
Move the switch to the right to enable the PPPoE pass through
function.
Move the switch to the right to enable the IPsec pass through
function.
Move the switch to the right to enable the L2TP pass through
function.
Move the switch to the right to enable the PPTP pass through
function.
Page 180 of 235
Configuring via Web-based Interface
Description
9