Table of Contents
Advertisement
Step 6:
Install the driver. If the 7.1 channel audio kit is used, the ALC883 driver must
be installed. Refer to Chapter 7 for driver installation
5.6.5 FDD Cable Connection
The FDD flat cable connects to the WSB-9152 to one FDD device. To connect an FDD to
the WSB-9152 please follow the instructions below.
Step 1:
Locate the FDD connector. The location of the FDD device connector is shown
in Chapter 3.
Step 2:
Insert the connector. Connect the FDD cable connector to the on-board
connector. See Figure 5-15. A key on the front of the cable connector ensures it
can only be inserted in one direction.
Figure 5-15: FDD Cable Connection
Step 3:
Connect the cable to an FDD device. Connect the connector at the other end
of the cable to an FDD device. Make sure that pin 1 on the cable corresponds to
pin 1 on the connector.
Page 92
WSB-9152 PICMG 1.0 SBC
Step 0:
instructions.Step 0:
Hide quick links:
Advertisement
Table of Contents
