Installation Notices; Installation Checklist - IEI Technology WSB-9152 User Manual

WSB-9152 PICMG 1.0 SBC

5.2.1 Installation Notices

WARNING:
The installation instructions described in this manual should be
carefully followed in order to prevent damage to the WSB-9152,
WSB-9152 components and injury to the user.
Before and during the installation please DO the following:
Read the user manual:
o
The user manual provides a complete description of the WSB-9152
installation instructions and configuration options.
Wear an electrostatic discharge cuff (ESD):
o
Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.
Place the WSB-9152 on an antistatic pad:
o
When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
Turn all power to the WSB-9152 off:
o
When working with the WSB-9152, make sure that it is disconnected from
all power supplies and that no electricity is being fed into the system.
Before and during the installation of the WSB-9152 DO NOT:
Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
Use the product before verifying all the cables and power connectors are
properly connected.
Allow screws to come in contact with the PCB circuit, connector pins, or its
components.

5.2.2 Installation Checklist

The following checklist is provided to ensure the WSB-9152 is properly installed.
Page 73