Dual Rs-232 Cable Connection; Figure 5-17: Connect The Lpt Device - IEI Technology WSB-9152 User Manual

Step 5: Connect LPT device. Once the LPT interface connector is connected to the
chassis, the LPT device can be connected to the LPT interface connector. See
Figure 5-17Step 0:\

Figure 5-17: Connect the LPT Device

5.6.7 Dual RS-232 Cable Connection

The dual RS-232 cable consists of two connectors attached to two independent cables.
Each cable is then attached to a D-sub 9 male connector that is mounted onto a bracket.
To install the dual RS-232 cable, please follow the steps below.
Step 1: Locate the connectors. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 2: Insert the cable connectors. Insert one connector into each serial port box
headers. See Figure 5-18. A key on the front of the cable connectors ensures
the connector can only be installed in one direction.
Page 94
WSB-9152 PICMG 1.0 SBC