Lan Connection (Single Connector); Figure 5-22: Lan Connection - IEI Technology WSB-9152 User Manual

WSB-9152 PICMG 1.0 SBC
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding WSB-9152 external peripheral interface connector making
sure the pins are properly aligned.

5.7.1 LAN Connection (Single Connector)

There are two external RJ-45 LAN connectors. The RJ-45 connectors enable connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.
Step 1: Locate the RJ-45 connectors. The locations of the USB connectors are shown
in Chapter 4.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the WSB-9152. See Figure 5-22.

Figure 5-22: LAN Connection

Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the onboard RJ-45 connector. Step 0:
Page 99