Table of Contents
Advertisement
7.1 channel audio kit
5.1 channel audio kit
5.6.2 IDE Cable Connection
The IDE flat cable connects the WSB-9152 to one or two IDE devices. To connect an IDE
HDD to the WSB-9152 please follow the instructions below.
Step 1:
Locate the IDE connector. The location/s of the IDE device connector/s is/are
shown in Chapter 3.
Step 2:
Insert the connector. Connect the IDE cable connector to the onboard
connector. See Figure 5-12. A key on the front of the cable connector ensures it
can only be inserted in one direction.
Figure 5-12: IDE Cable Connection
Step 3:
Connect the cable to an IDE device. Connect the two connectors on the other
side of the cable to one or two IDE devices. Make sure that pin 1 on the cable
corresponds to pin 1 on the
Page 88
WSB-9152 PICMG 1.0 SBC
connectorStep 0:
Hide quick links:
Advertisement
Table of Contents
