Eaton PowerXL DC1 20 Series Installation Manual page 98

3 Installation
3.6 Electrical Installation
3.6.2.1 Terminal capacities and stripping lengths
3.6.2.2 Control signal terminal connection information and functions
94
The terminal capacities and stripping lengths are listed in the following table.
Table 11: Control signal terminal sizes and designs
mm 2 mm 2
0.2 - 2.5 0.2 - 1.5
The functions that are set in the ex-factory and the electrical connection data
of all control signal terminals are listed in the following table.
Table 12: Factory-set functions of the control signal terminal
Connection Signal
terminal
1 +24 V Control voltage for DI1
- DI4, output (+24 V)
2 DI1 Digital Input 1
3 DI2 Digital input 2
4 DI3 Digital Input 3
AI2 Analog Input 2
5 +10 V Reference voltage,
Output (+10 V)
6 AI1 Analog Input 1
DI4 Digital Input 4
7 0 V Reference potential
8 AO1 Analog output 1
DO1 Digital output 1
9 0 V Reference potential
10 K13 Relay 1, N/O
11 K14 Relay 1, N/O
DC1...20... and DC1...OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
AWG mm in
24 - 12 5 0.2
Description
Maximum load 100 mA,
Reference potential 0 V
Notice:
Do not connect an external voltage
source!
+8 - +30 V (High, R
i
+8 - +30 V (High, R
i
• digital: +8 - +30 V (high)
• Analog: 0 - +10 V (R
0/4 - 20 mA (R
B
Can be switched with parameter P-16
• 1 - 10 kΩ
Maximum load: 10 mA
Reference potential: 0 V
• Analog: 0 - +10 V (R
0/4 - 20 mA (R
B
Can be switched with parameter P-16
• 1 - 10 kΩ
• digital: +8 - +30 V (high)
0 V = connection terminal 9
• Analog: 0 - +10 V, maximum 20 mA
Can be switched with parameter P-25
• digital: 0 - +24 V
0 V = connection terminal 7
Maximum switching load:
250 V AC/6 A or 30 V DC/5 A
Maximum switching load:
250 V AC/6 A or 30 V DC/5 A
M3
N/m ft-lbs mm
0.5 0.42 0.4 x 2.5
Default Setting
–
> 6 kΩ) Start enable FWD
> 6 kΩ) Start enable REV
Fixed frequency FF1
> 72 kΩ)
i
= 500 Ω)
–
> 72 kΩ) Frequency Reference
i
= 500 Ω) (fixed frequency)
–
Output Frequency
–
RUN
RUN