Eaton PowerXL DC1 20 Series Installation Manual page 72

3 Installation
3.3 Mounting
68
Dismantling from mounting rails
▶ To remove the device, push down the spring-loaded clip. A cutout
marked on the lower edge of the device is provided for this purpose.
A flat-bladed screwdriver (blade width 5 mm) is recommended for
pushing down the clip.
EMC
VAR
3
2
Figure 30: Dismantling from mounting rails
DC1...20... and DC1...OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
f 5 mm
(f 0.197")
1