Eaton PowerXL DC1 20 Series Installation Manual page 133

￫
On OLED displays, languages can be selected by pressing
START + ▲ simultaneously.
Display: Select Language.
The display language can be changed with the ▲ and ▼ arrow
keys. The selected language setting can then be saved by
pressing the OK button.
￫
If you want to use the START and STOP buttons to control the
DC1 variable frequency drive, the corresponding setting needs
to be enabled in parameter P-12 ("Local process data source")
regardless of which keypad type or model is being used
(integrated DX-KEY-LED or external DX-KEY-OLED)
Table 22: Keypad buttons
Button Attribute ID
OK
START
STOP
UP
DOWN
Note:
1) P-12 = 1 (one operating direction) or P-12 = 2 (two operating directions);
The operating direction will be reversed when the START button is pressed
2) Only if P-12 = 2
DC1...20... and DC1...OE1 Variable Frequency Drives 02/20 MN040059EN www.eaton.com
Explanation
• Navigating in parameter mode
• Opens and closes the parameter interface
(press the button and hold it down for more than two seconds)
• Saves parameter changes
• Changes the value being displayed: A, rpm, etc. (real-time
information)
• Starts the variable frequency drive
• Changes the operating direction
• Stops the variable frequency drive
• Reset – Resetting after fault message
1)
• Increases the speed
• Increment numeric value or parameter number
1)
• Decreases the speed
• Decrement numeric value or parameter number
4 Operational
4.5 Handling the keypad
1)
2)
if the motor is running
1)
129